We design and build production lines end to end
From melting to the end of the line, we bring six main processes together under single-source responsibility: equipment, automation and commissioning come from the same team. The solutions below are arranged in production order; each page describes the scope of the line, how it works and the options for integrating it into an existing plant.
Aluminium Melting and Holding Furnaces
The furnace does not only melt the metal; it also has to hold the temperature steady throughout casting. We size the melting and holding sides together, to suit your charging pattern.
DISCOVER
Metal Quality and Refining
If molten aluminium carries hydrogen and oxide, the defect only shows up after casting. We place the degasser, filter and refining units between the furnace and casting.
DISCOVER
Billet Casting Systems
Billet cast with an AirSlip mould comes out with an even surface, and the machining allowance drops. The pit, mould table and cooling water control are built as a single system.
DISCOVER
Ultrasonic Test Systems
Voids and inclusions inside a billet cannot be seen with the naked eye. Ultrasonic scanning runs within the line, and rejects are sorted out before they reach the press, without stopping production.
DISCOVER
Heat Treatment Systems
In homogenisation and in T4 and T6 treatment, every corner of the furnace must be at the same temperature. We design the air circulation and the load layout around your product.
DISCOVER
Automatic Loading & Unloading
A forklift waiting in front of the furnace gives away the cycle time you have gained. With conveyors, transfer cars and robot grippers, charging and unloading run unmanned.
DISCOVERWe answer frequently asked questions
about our solutions
Product pages give the data sheet of a single machine: capacity, dimensions, options. Solution pages describe the line in which those machines work together: process sequence, integration and scope of responsibility. Start from the product pages when selecting equipment, and from the solution pages when building a line.
No. Every solution can start from a single unit and be built in stages; we draw the layout with expansion in mind from the start. It is also possible to add a single piece of equipment to your existing line.
Process design, equipment manufacturing, installation, PLC/SCADA automation, commissioning and operator training. For civil works such as the pit, we supply the reinforced concrete design and the plant’s contractor carries out the construction.
Yes. Combustion system refurbishment, automation renewal or even adding a single station are all within our scope; we plan work on an operating line to interrupt production as little as possible.
After installation, the first heat-up, loaded tests and performance verification are carried out by our team; operator training is given during this time. We confirm the schedule together with the scope at the quotation stage.
Let’s plan your line together, process by process
Capacity, charging regime, site dimensions and energy infrastructure: furnace selection starts with this information. Tell us about your existing line, and we will prepare the quotation for your process.
Request a Quote





